Sorry, another boundary wire issue...
Any suggestion with these symptoms:
- intermittent, now permanent boundary wire error message
- boundary wire is ok - 4 ohm resistance
- no green light even when rewired with just a short jumper between terminals
- no loops or crossing of wires
I did a reset as suggested in the FAQ. Strangely, I got NO green light, but it happily set off doing a border cut. Then it stopped about 70% of the way around the boundary and gave the wire error again.
The mower works fine on the base in our other garden.
Sounds as though I need to send to Bosch. Anything else I could try?
How do I determine whether the cause could be failed power supply to the base? Presumably that would also result in no green light. Will the mower tell me if it has no power on the base?