Indego last run error #1138 / started getting stuck all the time

[rskadk]

Anybody can answer what I can do about my robot suddenly started throwing this error all the time. Suddenly it gets stuck all the time. Before it was moving without any issues.. I have the sensor setting to low... it's like some sensor kicks in way to early and then it stops.

 

[TW_Stuttgart]

The gras is too high.

 

[TW_Stuttgart]

See also:

[FAQ] Die meist gestellten Fragen zur zweiten Generation [Aktualisiert: 05.07.2022]

Hinweise zur Lagerung im Winter / Winterservice von Bosch Während der Wintersaison sollten der Indego sowie die Ladestation an einem sicheren und trockenen Ort gelagert werden. Wenn die Ladestation fest verbaut ist, dann kann alternativ auch nur die Signalsäule entnommen werden. Bosch...

www.roboter-forum.com

 

[rskadk]

The gras is too high.

It has been running fine before without any issues. The only reason I could think of is I cleaned it below for a couple of weeks ago - maybe some water has damaged it / some sensor?

 

[TW_Stuttgart]

If you have cleaned the Indego from below with water, this could be the cause of your problems. It is not waterproof at the bottom.

 

[rskadk]

If you have cleaned the Indego from below with water, this could be the cause of your problems. It is not waterproof at the bottom.

If that is the case - any suggestion on what I can do? I suspect the wheel engine not to have the same power as it did previously and then it gives up in and much earlier stage if there is just a little resistance. I have newer had the error life this before even dough the grass was much higher..

Alternative maybe the sensor can somehow be removed so it doesn’t give up so easy?